«Previous    Next»
"Old-Style" Plastic Vent Installs On Existing Gas Lugs
Rex Farr, Lewistown, Mont.: “Tired of your self-venting gas jug not venting? Here’s the solution – an ‘old-style’ plastic vent that installs with minimal tools on existing gas jugs.”
  To install, select a location on top of the jug that’s relatively flat and drill a 1/2-in. dia. hole in it. Apply a small amount of gas-resistant sealant on the plug to aid in sealing. Then insert the plug into the hole and give it a firm tap with a hammer.
  The vent sells for $3 plus $4 S&H. Installation and ordering information is available at: www.vent-sol.com.



  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2012 - Volume #36, Issue #3