«Previous    Next»
Indented Groove Funnel
The "burpless funnel" made by Rick Mabeus that was featured in the last issue of FARM SHOW seemed rather complicated and difficult to keep clean. I think a better solution to the problem would be to put an indented groove down the funnel spout. This would vent air out of a crankcase or gear box when being filled where there's no other way for air to escape except for out the fill hole.
(Jack Kiser, 155 E. CR-89, Fremont, Ohio 43420)

  Click here to download page story appeared in.

  Click here to read entire issue

To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
1996 - Volume #20, Issue #2