Raise Ttruck's Endgate
 ✖  |
I enjoy FARM SHOW very much and look forward to every new issue. I'd like to pass along a simple device I made to raise my truck's endgate for faster unloading at elevators. Using some 1/2-in. rod and 1/4-in. flat irons, and bending them as shown in the photo, I made an easy lift. I slipped a piece of pipe over the rod before I finished bending them to make a more comfortable handle. I also installed some lightweight slide irons for the door to slide against and I use a little oil to help it slip. (Roger Hagemann, Rt. 3, Box 51, Wells, Minn. 56097)
Click here to download page story appeared in.
Click here to read entire issue
Raise truck's endgate TRUCKS Accessories 14-3-30 I enjoy FARM SHOW very much and look forward to every new issue. I'd like to pass along a simple device I made to raise my truck's endgate for faster unloading at elevators. Using some 1/2-in. rod and 1/4-in. flat irons, and bending them as shown in the photo, I made an easy lift. I slipped a piece of pipe over the rod before I finished bending them to make a more comfortable handle. I also installed some lightweight slide irons for the door to slide against and I use a little oil to help it slip. (Roger Hagemann, Rt. 3, Box 51, Wells, Minn. 56097)
To read the rest of this story, download this issue below or click
here to register with your account number.
