«Previous    Next»
Tree Brace Sets Up Fast
“Our new Tree Hugger Brace kit lets one person stake a tree in only about 5 min. without using specialized tools. It can be easily removed and reused,” says Farrell Gerber, Tree Hugger Solutions, Weston, Fla.
The kit comes with 3 tree brace support holders, 2 quick-adjust metal bands with screw-type clamps, and 3 protective cushion squares.  The support holders come with slots designed to accept 2 by 4’s, and are strapped to the tree with the metal bands.
You place the cushion square on the back side of each support holder using double sided tape (included) and then insert the 2 by 4 into the slot. All the support holders should be attached at the same height on the tree trunk. Then insert the metal bands through the slots and around the trunk. For added support, you can insert a pair of screws through pre-drilled holes near the bottom of the support holder.
“The Tree Hugger is available in both fixed and adjustable models,” says Gerber. “The slot on the adjustable model has a built-in articulated joint, which lets you change the angle of the 2 by 4 anywhere from 20 to 120 degrees just by lifting the board up or down. Makes it easy to compensate for any obstacles and for non vertical trunks.”
The fixed model Tree Hugger sells for $69.95; the adjustable model sells for $79.95, which includes ground freight within the contiguous U.S.
Contact: FARM SHOW Followup, Tree Hugger Solutions, LLC, 2900 Glades Circle, Suite 700, Weston, Fla. 33327 (ph 954 719-8733; sales@treehuggerusa.com; www.treebrace.com).



  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2020 - Volume #44, Issue #1