2009 - Volume #33, Issue #1, Page #38[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story | Read this issue]
Hand Units "Bend And Hem" Sheer Metal
"Metal roofing contractors and sheet metal contractors have to use a bender or other hemming device," says A.G. Zalal, North American Bocker. "The Duo Bender, Disc-O-Bender and Mini-Disc-O-Bender will bend and hem any length quickly and easily."
The Duo Bender can be set for legs with a length of up to 14 in. and up to 24 gauge in most materials. Engraved scales on the metal legs make it easy to set and adjust lengths to be folded. Simple one-handed back and forth movements quickly bend the metal into a 90 degree leg.
The working edge of the Disc-O-Bender slips over legs from 3/8-in. to 1 1/4 in. long. Again, it's simple back and forth movements that bend the leg down to a maximum 180 degree hem. It works on thicknesses of up to 0.031 in. (22 gauge in stainless steel) for common materials. The company promises no damage to painted or coated material.
The Duo-Bender and the Disc-O-Bender are each priced at $950. The Mini Disc-O-Bender is priced at $498.
Contact: FARM SHOW Followup, North American Bocker, 302 West Lane St., Raleigh, N.C. 27603 (ph 919 832-8481 or 888 262-5371; fax 919 832-8493; firstname.lastname@example.org; www.nabocker.com).
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.