1999 - Volume #23, Issue #5, Page #40
[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story
| Read this issue]
Hydraulic Cylinder Shaft Used To Make Inexpensive, Heavy Hammer
Norman Smith, Walsh, Ill.: "I used part of an old hydraulic cylinder shaft to make an inexpensive, heavy hammer. The shaft had been accidentally bent. I cut off a length of the shaft and burned a hole through it. I used a length of sq. steel tubing to make the handle and butted the two pieces together, then ran a bolt through the shaft and tubing and fastened a nut to the bottom of the bolt."
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.
