«Previous    Next»
Readers Respond To Exploding Toolbar Story
I run a small shop here in Colorado. I've never had a problem with a toolbar explosion but I can see how it could happen. In my opinion, the best thing to do if you're worried about it is to use a hydraulic press to punch a hole in the bar to let the gasses escape. A punch ordinarily does not create a spark. Manufacturers should leave vent holes to allow gases and moisture to escape. (Darman Fast, Cedar Edge, Colo.)


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
1999 - Volume #23, Issue #3