«Previous    Next»
Readers Respond To Exploding Toolbar Story
Filling toolbars with metal filings and punch-outs obviously isn't such a good idea. Moisture will condense inside anything that's sealed tight. I know because water condenses regularly inside the water lines in my dairy barn. It'll also condense inside a metal gas can. It condenses because of the difference in temperatures inside and outside. When a toolbar is welded shut on both ends water will condense inside it and between the metal filings and punch-outs. It might not take much water to start a reaction. I think any sealed toolbar should have vent holes in it. I made my own toolbar and made sure that I didn't seal it up because I was concerned about this problem. (Dan Hill, Dismont, Maine)


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
1999 - Volume #23, Issue #3