«Previous    Next»
Case 4WD Repowered With Cummins Diesel
"When the engine in my 1970 Case 1470 4-WD tractor failed, I replaced it with a 290 hp 6-cyl. Cummins diesel salvaged from an old 1969 semi truck that I bought for $2,500. By buying the entire semi I got all the auxilliary parts I needed," says Tom Pyfferoen, Rochester, Minn.
Pyfferoen lengthened the tractor frame 1 ft., widened the front grille 4 in., and made a new hood to accomodate the big 855 in-line diesel. He side-mounted the semi engine's exhaust and air cleaner.
"It's my primary tillage tractor," says Pyfferoen, who uses the tractor to pull a 14-ft. chisel plow and 30-ft, field cultivator. "It has a lot more power than the original 145 hp Case engine and has tremendous torque. I spent an extra $550 for a new bell housing and to rework the flywheelbutIsoldtheoriginalCaseengine for $800. The Case engine needed work, and I had already spent quite a bit of money repairing it. I didn't want to spend the money for a new high horsepower 4WD tractor because I was putting fewer and fewer hours on it every year.
"I bought the semi tractor from a local implement dealer. The engine had over 100,000 miles but had been rebuilt a couple of times. It had been about 25,000 miles since the lastrebuild By buying the entire semi tractor I got access to all the components that go with the engine, including gauges, radiator, engine mounts, fuel line fittings, air cleaner, alternator, and exhaust pipe. Such parts would cost a lot of money if purchased new. If my engine ever fails, I can buy another used Cummins for about $2,000.
"The engine was easy to install. I had to make only a few modifications on the tractor. The radiator was bigger so I had to widen the grille 4 in. and raise it 6 in. and I used sheet metal to build a new hood. It's held down with rubber straps and is hinged in front which makes the engine easy to service. I used square steel tubing to build a framework that supports the side-mounted muffler. Side-mounting reduced noise and vibration in the cab. I used 12-in. channel iron to lengthen the tractor frame.
"The Case tractor has the same transmission and bell housing found on GM and Ford trucks so I was able to buy the bell housing I needed from a local truck dealer. I reworked the flywheel by drilling bigger holes in it to fit the bolt pattern on the new engine. I used the tractor's original clutch and pressure plate."
Contact: FARM SHOW Followup, Tom Pyfferoen, 6225 19th St. N.W., Rochester, Minn. 55901 (ph 507 2884806).


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
1992 - Volume #16, Issue #6