«Previous    Next»
Deep Sockets Extract Damaged Nuts, Bolts
For rusted, rounded or seized bolts and nuts, Gear Wrench offers their 10-piece 1/2-in. drive Bolt Biter extraction deep sockets.
    Nuts and worn bolts can make it almost impossible to fit a wrench or socket tight enough to withstand hand or impact torque energy. Using a soft-faced hammer, Bolt Biter sockets can be tapped into position over any amount of rust and corrosion for secure holding power. Their tapered flute design bites into the flat side of a nut or bolt to easily seat on rusted fasteners.
    Acme’s sockets are built from chrome molybdenum alloy steel for extra strength and durability and feature a bi-directional flower-shaped design that can be used to loosen or tighten damaged fasteners. A black oxide finish helps them resist corrosion. Sockets fit both SAE and metric nuts.
    The square drive comes with a hex base in case the targeted bolts can’t be accessed with an impact. A wrench or pliers fit the exterior of the sockets if needed.
    Bolt Biter deep sockets in a 10-piece case sell for $149.99 plus S&H.
    Contact: FARM SHOW Followup, Acme Tools, 1603 12th Avenue N., Grand Forks, N.D. 58203 (ph 877-345-2263; support@acmetools.com; www.acmetools.com).


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2023 - Volume #47, Issue #3