Hitch Problem Solved
 ✖  |
Steve Faber, Tiffin, Ohio: “I had a hitch that was slightly loose in the receiver tube, as they usually are. Besides the annoying rattle, the utility trailer swayed slightly but continuously. I sorted through my scrap metal until I found just the right thickness to take up the clearance. I cut and bent it to fit, with a small flange on top that keeps it from going in too far when installing. The pin goes through a hole in it to hold it in place. No more sway or rattle.”
Click here to download page story appeared in.
Click here to read entire issue
Hitch Problem Solved HITCHES Steve Faber Tiffin Ohio: “I had a hitch that was slightly loose in the receiver tube as they usually are Besides the annoying rattle the utility trailer swayed slightly but continuously I sorted through my scrap metal until I found just the right thickness to take up the clearance I cut and bent it to fit with a small flange on top that keeps it from going in too far when installing The pin goes through a hole in it to hold it in place No more sway or rattle ”
