2020 - Volume #44, Issue #1, Page #28[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story | Read this issue]
Semi Trailer Converted To Big Capacity Grain Hauler
The wagon holds about 500 bu. of corn and is equipped with a rear-unloading auger at the bottom. It weighs about 9,000 lbs. empty and almost 40,000 lbs. when fully loaded. Davis pulls it behind an IH 2 plus 2 tractor with 170 hp.
The wagon’s running gear, tandem axles, and air brakes came off the semi trailer. He used 10-in. channel iron to build a frame that attaches to the tandem axles. He used 4 by 8 sheets of 14-ga. steel and 3 and 4-in. channel iron to build the box, which is supported by 4-in. vertical “ribs”. Channel iron was also used for the tongue. A homemade cable and pulley system, connected to a hydraulic cylinder, is used to activate the brakes.
Davis used a length of 6-in. dia. well casing to house the unload auger, which operates off tractor hydraulics. “I cut a series of 12-in. wide slots about 1 ft. apart into the casing and covered them with sliding metal doors, which I can manually open or close by turning a screw on back of the wagon. Makes it easy to control the flow of grain,” says Davis.
Contact: FARM SHOW Followup, William Davis, 1250 Long Hollow Road, Masontown, W. Va. 26542 (ph 304 435-9622; firstname.lastname@example.org).
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.