«Previous    Next»
Rear Wheel Puller Fits Deere Tractors
“Our Rear Wheel Puller is designed to fit John Deere A, B, G and H tractors. The kit comes with a 1-in. thick round puller plate with elongated holes in it and 4 threaded bolts. You put the nut on the center bolt with 1/2 in. of the bolt sticking out of the plate, then insert the bolt into the turning hole in the end of the axle.
  “Screw the other 3 bolts into the hub, making sure the bolt sticks through the back side of the hub. Then put the puller plate on the 3 bolts and screw nuts onto them until the pressure pulls the plate up square with the bolts.
  “The Rear Wheel Puller sells for $150 plus $14 shipping by USPS Priority Mail. Additional bolt assemblies for other models sell for $40 plus S&H. Comes with a money-back guarantee.”



  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2018 - Volume #42, Issue #6