Problem Solved On Global Attachment Quick-Tach Deere Front-End Loaders
Fritz Groszkruger, Dumont, Iowa: “I’ve got a ‘global attachment’ quick-tach Deere front-end loader. To release attachments, you pull out the handle and turn. The problem I had was that if I hit a bump while the pins were out, it would snap back in again. So I would have to get off the tractor and pull it out again. I solved the problem by building up the rounded edge of the pin with weld and then grinding it smooth. The keyhole that the wider part of the pin turns into was punched in, making it slightly worn so I built that up as well. Now it takes a heck of a bump to pop it back in.”
Click here to download page story appeared in.
Click here to read entire issue
Problem Solved On Global Attachment Quick-Tach Deere Front-End Loaders TRACTORS Loaders Fritz Groszkruger Dumont Iowa: “I’ve got a ‘global attachment’ quick-tach Deere front-end loader To release attachments you pull out the handle and turn The problem I had was that if I hit a bump while the pins were out it would snap back in again So I would have to get off the tractor and pull it out again I solved the problem by building up the rounded edge of the pin with weld and then grinding it smooth The keyhole that the wider part of the pin turns into was punched in making it slightly worn so I built that up as well Now it takes a heck of a bump to pop it back in ”
To read the rest of this story, download this issue below or click
here to register with your account number.