1992 - Volume #16, Issue #3, Page #25[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story | Read this issue]
Sensor Tester Checks Your ElectronicsTesting virtually any type of electronic monitor - including grain loss pads - is easy with this new Sensor Tester developed by Bruce Nelson, Aurora, Colo.
"We've tested it extensively over the past two years in equipment dealerships. Works on magnetic, impact, and photoelectric sensors used by all manufacturers, including seed tube monitors, shaft speed sensors, position sensors, bin sensors and any other monitor used on tractors, combines and other equipment. Eliminates the need to `test by substitution' with new parts - you can check the actual part while it's still on the machine. It'll even test ganged sensors so you can isolate wiring problems," says Nelson.
The tester is powered by a 9-volt battery and is just 2 3/8 by 3 3/4 by 1 in. in size. Requires no adapters or calibration. Sells for $54.95. "We've had tremendous interest from dealers but farmers who do their own maintenance will also find it'll save them a lot of time and hassle," points out Nelson.
Contact FARM SHOW Followup, Gremlin Electronic Service, 19878 E. Cornell Ave., Aurora, Colo. 80013 (ph 303 680-0031).
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.