«Previous    Next»
Cutterbar Slides Easier On New Guides

A new Roller Guide system designed for the popular SCH EasyCut cutting system replaces the spacer bars that normally support the knifeback in cutter bars. The new guides are designed to extend the working life of the cutterbar.
  "Switching to Roller Guides reduces knifeback wear and breakage, allows the knife to slide between guards easier with less friction, requires less power, and reduces platform vibration," says Dave Burgei, president.
  The all-steel construction Roller Guides are made with a hardened roller, sealed bearings and a cap to keep dirt out. Roller Guards are priced at $14.50 each and installed every 18 in. Installation is a simple matter of removing two knife guards and the spacer bars, which are held in place with the guard bolts. The roller guards are then secured when the knife guards are reinstalled.
  Contact: FARM SHOW Followup, S.I. Distributing Inc., 03221 Barber Werner Road, St. Marys, Ohio 45885 (ph 419 394-2989 or 800 368-7773; email: info@sidist.com; website: www.sidist.com).


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2005 - Volume #29, Issue #4