«Previous    Next»
Solution To Dented Grain Auger
Victor E. Jans, Cupar, Sask.: "My grain auger got dented when someone backed into it. The flighting was rubbing on the auger tube. I didn't want to take out the flighting so I came up with another solution. I welded a large nut to the outside of the auger where it was bent and then turned in a long bolt. I pulled out the dent by pulling on the bolt, thus straightening the tube. No need to remove the flighting."


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2003 - Volume #27, Issue #3