"Straw Boss" Bale Man
 ✖  |
Here's a photo of a "Straw Boss" bale man that we recently put together. The legs are hard core bales about 2 1/2 ft. in diameter while the soft core bale used for the body is about 5 1/2 ft. in diameter. To make the hat brim I cut off part of a ribbed front tractor tire, then mounted a 12-gal. barrel on top of it and duct taped black plastic to it. The eyes and buttons were made by cutting up a blue plastic pail while the nose and mouth were cut out of a red pail. To make the arms I shoved sticks into the body and covered them with cardboard tubing that was originally used to hold rolls of carpet. A glove is attached to the end of each arm. (Victor Nikiforuk, Box 375, Two Hils, Alberta T0B 4K0 ph 403 657-2855)-
Click here to download page story appeared in.
Click here to read entire issue
"Straw Boss" Bale Man CROPS Straw 22-5-33 Here's a photo of a "Straw Boss" bale man that we recently put together. The legs are hard core bales about 2 1/2 ft. in diameter while the soft core bale used for the body is about 5 1/2 ft. in diameter. To make the hat brim I cut off part of a ribbed front tractor tire, then mounted a 12-gal. barrel on top of it and duct taped black plastic to it. The eyes and buttons were made by cutting up a blue plastic pail while the nose and mouth were cut out of a red pail. To make the arms I shoved sticks into the body and covered them with cardboard tubing that was originally used to hold rolls of carpet. A glove is attached to the end of each arm. (Victor Nikiforuk, Box 375, Two Hils, Alberta T0B 4K0 ph 403 657-2855)-
To read the rest of this story, download this issue below or click
here to register with your account number.
