«Previous    Next»
Work Table Lifted By Hydraulic Jack
To work on mowers, pressure washers, and other equipment that’s too heavy to lift, Bob Payne, Coldwater, Miss., bolted a lift table to the lift plate on a large hydraulic jack. The 3/4-in. plywood deck has hinged 2 by 4 sides that can be latched shut. Car ramps make it easy to roll equipment onto the platform when it’s down. Then you close the sides and crank it up with the jack.
Once the lift table is at working height, Payne puts a sawhorse under each end and lowers the table onto them. “I can use the lift table wherever I need it and it stores under a workbench. It’s easy to unbolt the table from the lift jack if you need the jack for other uses,” he says. Contact: FARM SHOW Followup, Bob Payne, 65 Wallace Road, Coldwater, Miss. 38618.


  Click here to download page story appeared in.



  Click here to read entire issue




To read the rest of this story, download this issue below or click here to register with your account number.
Order the Issue Containing This Story
2021 - Volume #45, Issue #3