Holder Organizes Tools In Shop
 ✖  |
John Matthews, Welland, Ontario: “My son David enjoys finding ways to organize tools in his shop. He made a holder for oversized (1/2-in. shank) drill bits by drilling through 2 sheets of 14-ga. plate that were welded together. He drilled 28 holes for the shanks that are 33/64-in. wide, ground off the welds, and used 1/4-in. all-thread to separate the plates and to serve as legs. There’s a layer of foam at the bottom for bits that don’t have a shoulder.”
Click here to download page story appeared in.
Click here to read entire issue
Holder Organizes Tools In Shop FARM SHOP Tools John Matthews Welland Ontario: “My son David enjoys finding ways to organize tools in his shop He made a holder for oversized 1/2-in shank drill bits by drilling through 2 sheets of 14-ga plate that were welded together He drilled 28 holes for the shanks that are 33/64-in wide ground off the welds and used 1/4-in all-thread to separate the plates and to serve as legs There’s a layer of foam at the bottom for bits that don’t have a shoulder ”
