He Made A Pry Bar From A Pickup Leaf Spring
✖ |
Dave Neufeld, Waverly, Kan.: "I made a pry bar from a pickup leaf spring. It's thin, yet wide and strong. I had to heat it to bend one end. There was no need to sharpen the ends since it already had pretty thin ends but some springs would probably need that. The bar works great for removing wood trim without scarring, and the curved section is useful for lifting sheet rock an inch or so into position. I'm sure there will be many other uses I haven't thought of yet."
Click here to download page story appeared in.
Click here to read entire issue
He Made A Pry Bar From A Pickup Leaf Spring FARM SHOP Tools 33-5-36 Dave Neufeld, Waverly, Kan.: "I made a pry bar from a pickup leaf spring. It's thin, yet wide and strong. I had to heat it to bend one end. There was no need to sharpen the ends since it already had pretty thin ends but some springs would probably need that. The bar works great for removing wood trim without scarring, and the curved section is useful for lifting sheet rock an inch or so into position. I'm sure there will be many other uses I haven't thought of yet."
To read the rest of this story, download this issue below or click
here to register with your account number.