1999 - Volume #23, Issue #3, Page #37
[ Sample Stories From This Issue | List of All Stories In This Issue | Print this story
| Read this issue]
How To Fix A Loose Head On Wooden Handled Hammers
Mike Graham, Edison, Ohio: "You can fix a loose head on any size wooden handled hammer using this simple, low-cost method."You simply apply JB Weld generously to the end of the handle and inside the head, then put the head back on the handle and reset the head. I first clean the handle thoroughly with sandpaper or steel wool. Likewise, I clean up the inside of the head with a small wire brush. In 24 hours, after the JB Weld sets, you've got a hammer that's as good as new.
"I've also used this repair on a couple of 4-lb. sledges I use to break up firewood. It's a permanent repair."
Click here to download page story appeared in.
Click here to read entire issue
To read the rest of this story, download this issue below or click here to register with your account number.