You have reached your limit of 3 free stories. A story preview is shown instead.
To view more stories
(If your subscription is current,
click here to Login or Register.)
Wheeled Bucket Stand
Chad Travis, Drasco, Ark.: “I made a wheeled bucket stand for a local auto garage. It’s designed to support a 5-gal. bucket of fluid 3 1/2 ft. off the floor, which makes pumping fluid into gearcases a much easier job when the vehicle is up on a lift. One person can hold the hose in the gearcase fill hole and pump in fl
.......... You must sign in, subscribe or renew to see the page.
You must sign in, subscribe or renew to see the flip-book
Wheeled Bucket Stand FARM SHOP Maintenance Chad Travis Drasco Ark : “I made a wheeled bucket stand for a local auto garage It’s designed to support a 5-gal bucket of fluid 3 1/2 ft off the floor which makes pumping fluid into gearcases a much easier job when the vehicle is up on a lift One person can hold the hose in the gearcase fill hole and pump in fluid without having to reach down to the floor “The stand’s center support is made from a 2-ft length of pipe welded to an angle iron base The bucket rests in a tray made from 1-in angle iron and 10-ga sheet metal The back support is made from 1/4 by 1-in flat strap bent in a half circle “You just roll it under the vehicle The raised stand makes the bucket much easier to reach than if it was on the floor ”
To read the rest of this story, download this issue below or click
here to register with your account number.